03During construction
Construction Set Out for Houses, Duplexes and Pools
A set out marks where the building goes, using the approved plans and the surveyed boundaries. Your builder and trades work from those marks, so setbacks and levels match the approval.
When you need it
Is this the survey you need?
- Starting a new house, duplex or granny flat
- Pegging a pool before excavation
- Setting out an extension close to a boundary
- The building must sit exactly at its approved setbacks
- Replacing pegs lost during excavation
What's included
What we survey and show
- Check of the architectural and engineering drawings before site
- Boundaries confirmed before setting out
- Building corners and main grid lines pegged
- Offset pegs placed clear of the excavation
- Pool and granny flat outlines
- Benchmark on AHD for pad and floor levels
- Setbacks checked against the approval
- Record of what was set out and from which drawing revision
Good to know
Set out from the right drawings
A set out is only as good as the drawings it comes from. Before going on site, Taha checks the architectural and engineering drawings against each other and against the boundaries. If dimensions don't add up, or a setback looks tight, you hear about it before the excavator arrives. Each set out is recorded against the drawing revision used, so there is a clear trail if questions come up later.
Offsets and benchmarks
Corner pegs rarely survive excavation, so we place offset pegs clear of the work, at set distances from the building lines. A benchmark on AHD is left on site for the pad, footings and formwork. It uses the same height datum as the detail survey, so the levels on the approved plans can be built and checked on the ground.
How it works
From quote to signed plan
- CH 0.00
Send the drawings
Architectural, structural and stormwater drawings, plus any survey we did not do.
- CH 25.00
Drawing check
The drawings are checked against each other and the boundaries.
- CH 50.00
Site set out
The building is pegged with offsets and a benchmark.
- CH 75.00
Record
You receive a record of what was set out and the benchmark height.
What you get
Delivered to you
- Pegs & offsets on site
- Benchmark on AHD
- Set out record
Checked and signed by Taha Abdo, Registered Surveyor SU010105.
Who it's for
We send the files to you, or straight to your architect, builder, engineer or certifier.
- Builders
- Homeowners
Questions
Common questions
What do you need before the set out?
The current construction drawings, architectural, structural and stormwater, plus the detail survey if we did not do it. Let us know about anything that has changed since approval. The site should be clear enough to place pegs and see between them.
Do the boundaries need checking first?
Yes. Buildings are set out from the boundaries, not the fences. If we have not surveyed the site before, the boundaries are checked as part of the job so setbacks are measured from the correct line.
Can you set out just a pool or granny flat?
Yes. Pools, granny flats, garages and extensions are set out the same way, from the plans and the boundaries. Smaller jobs like these are quoted on their own, with a fixed fee.
Can you come back if pegs get knocked out?
Yes. Lost or disturbed pegs can be replaced from our records. Because the original set out is recorded, the replacements match exactly what was set out the first time, with no guesswork.
Related services
Formwork & level checks
Confirm formwork, slab, floor and ridge heights before the next stage.
→Stage 03Stormwater set out
Pipes, pits, OSD tanks and driveways set out to the engineer's levels.
→Stage 03Cut & fill volumes
Measured cut, fill and excavation volumes for pricing and checking earthworks.
→Get a quote
Send us the address.
We come back with a fixed fee that lists exactly what is included. Not sure which survey you need? Tell us what you are building.